Looking for GME Telemetry radio dealer software (Australia NZ) for TX3600-TX3800. I have a UHF CB repeater that uses 2 x TX3600T. The TX radio OP device has failed and I want to either swap the RX/TX radios around or convert a spare TX3800 PMR radio to a telemetry version as the repeater TX radio. Both TX and RX radios are connected to a RP3800 interconnect board. I understand I actually need to "flash" new firmware into the TX3800 using a different cable (9 PIN D to 10 pin header inside radio) to make it work as a telemetry radio. Of course with my existing software I can configure the TX3800 to accept control from the TX3600 RX radio, but I'd rather just swap around the failed radio and that's why I need the Telemetry Software to reconfigure them. Cheers.
Sent from my SM-G900I using Tapatalk
GME Telemetry Radio Software
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
- Newly Registered Users
- Posts: 3
- Joined: Tue Nov 14, 2017 12:50 pm
- Phantom
- Forum Manager
- Posts: 1306
- Joined: Thu May 15, 2008 12:28 pm
- Location: SE QLD
Re: GME Telemetry Radio Software
Welcome to the forum. Interesting first post
- paul02
- Newly Registered Users
- Posts: 2
- Joined: Thu Nov 23, 2017 3:20 pm
Re: GME Telemetry Radio Software
[quote="MarkSR24"]Looking for GME Telemetry radio dealer software (Australia NZ) for TX3600-TX3800.
Sounds like you need CCK3600 software
Keep looking, nothing worst than asking questions and getting no replies.
If I can help will send private post
Sounds like you need CCK3600 software
Keep looking, nothing worst than asking questions and getting no replies.
If I can help will send private post
- paul02
- Newly Registered Users
- Posts: 2
- Joined: Thu Nov 23, 2017 3:20 pm
Re: GME Telemetry Radio Software
All done for you MarkSR24, latest version for TX3600T and TX3600P. That's how helping on forum's should be ; )
-
- Newly Registered Users
- Posts: 2
- Joined: Fri Feb 26, 2016 12:13 pm
Re: GME Telemetry Radio Software
Hi Paul02 do you know of any programming software for GME CM1039U series radios
Have a happy Christmas
Colin
Have a happy Christmas
Colin