Hello!
I am trying to communicate with a barcode scanner through a virtual serial COM port (CDC). If I enable the "continuous reading" I can easily read a barcode with a continuous VISA reading loop. However I do not want the scanner to be on continuous reading. I want to use the pull trigger command. I am trying to send this command to the scanner but nothing happens.
7 bytes are written, but no bytes are received(no response)
Anyone who can help?
Serial communication Motorola Barcode scanner
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
- Newly Registered Users
- Posts: 2
- Joined: Mon Sep 18, 2017 10:41 pm