Hi all,
I have an IC-400 and the CS-400 cloning software but now I also have an IC-450 that I want to setup the same, I haven't been able to find a copy of the CS-450 cloning software and I'm hoping someone on here is able to help me out.
Thanks,
Peter
CS-450 Cloning Software
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
- Newly Registered Users
- Posts: 3
- Joined: Sun Jun 05, 2016 4:10 pm
-
- Newly Registered Users
- Posts: 1
- Joined: Wed Jan 24, 2018 8:52 am
Re: CS-450 Cloning Software
Digging up this old post to say that there's users software on the iCom Australia website, but without a product ID it's useless. I haven't found a working product ID for the CS-450 software yet.