Selcall 400pro
Posted: Thu Jun 09, 2016 9:15 pm
So reading everywhere on this forum and web to try and get this up and running on the Icom 400pro.
If someone can give me a rough idea I'm sure I can pick it up.
in the editing software its under 5tone, there is 1-8 (channels)or RX code group and 1-32 of TX code groups.
How does this work for example?
if I enable the codes on TX channel 3, will this transmit on repeater 3 (channel 3 in my UHF bank)?
hope someone can make sense of this dribble
If someone can give me a rough idea I'm sure I can pick it up.
in the editing software its under 5tone, there is 1-8 (channels)or RX code group and 1-32 of TX code groups.
How does this work for example?
if I enable the codes on TX channel 3, will this transmit on repeater 3 (channel 3 in my UHF bank)?
hope someone can make sense of this dribble