I'm having problems cloning, i have 2 ic-f60 radios, one i can program fine but the new one (second hand off ebay from usa) doesn't work it says.....
Connected transceiver is not compatible model.
Check the following:
- Appropriate cloning software for the transceiver is being used.
- The revision number of the transceiver.
The only difference in the radios is the one that wont clone is a Intrinsically safe model serial no 8201xxx
the one that works is standard model serial no 1201xxx
i have tried CS-F50 ver 1.1, ver 1.4, ver 1.7, ver 2.1, & CS-F50V ver 3.1, none seem to work, is there another version to try or am I missing something else?
Can someone please help?
Cheers.
Icom IC-F60 problem cloning
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
- Newly Registered Users
- Posts: 1
- Joined: Fri Jun 01, 2012 6:39 pm
-
- Newly Registered Users
- Posts: 3
- Joined: Fri Aug 31, 2012 4:54 pm
Re: Icom IC-F60 problem cloning
Hi b666t
I am having similar problems, am helping the local SES support group program some IC-F60's and managed to program most of them with the CS-F50MDC software (v2.1) as v1.7 and 2.1 of the CS-F50 software didn't work at all. I'm also looking for CS-F50 v1.4 to give it a try on three radios.
Pat
I am having similar problems, am helping the local SES support group program some IC-F60's and managed to program most of them with the CS-F50MDC software (v2.1) as v1.7 and 2.1 of the CS-F50 software didn't work at all. I'm also looking for CS-F50 v1.4 to give it a try on three radios.
Pat
-
- Newly Registered Users
- Posts: 2
- Joined: Thu Jun 05, 2014 8:29 pm
Re: Icom IC-F60 problem cloning
Was hoping someone had the standard / original icf file for the F-60 please . Have had an oppsie moment and over written my original file .. Now only have 4 channels