Hopefully someone can help.
I have a Yaesu 120D and start using SmartSearch
When using smartsearch it will add any signals it picks up and add them to the memory bank 500-520
after it picks up the signals I can check each one and that's fine.
Is there any way to go back and check memory bank 500-.520 as I can only access them only after the initial scan.
Thanks
Ray
Yaesu & Smart Search
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.