G'day Guys,
Still trying to figure a few things with this scanner.
I have encountered an issue that I can't bullshit my way through.
The scanner is set up to scan a number of profiles (i.e. Dist 04, Dist 08, Dist 27, MMR, Aviation)
All the other profiles are locked out.
All the service types are selected and there are no avoids on.
When it scans it will miss the Aviation profile I have checked by scanning the systems to find that it misses it out completely.
The AM channels are all correct.
There are no avoids set
The profile is ON to scan in scan selection
The service type for this profile is ON
I have looked at everything in the Sentinel program and it all looks good.
I have looked at everything in the Scanner itself and it all looks good.
Does anyone have any ideas that will prevent my scanner being impact tested against the bricks of my house?
Signed sincerely
Confused and aggravated
Scanning issues with the UBCD436-PT
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
fletchba
- Registered User
- Posts: 13
- Joined: Thu Jul 04, 2013 8:18 pm
-
frankc
- Registered User
- Posts: 16
- Joined: Sun Dec 30, 2007 12:40 am
- Location: Middle Swan WA
- Contact:
Re: Scanning issues with the UBCD436-PT
When you wrote to the scanner did you select Erase Favourites Lists on Scanner and Force Write Full Database ? Cosdoing that will ensure any previous profiles will be erased.fletchba wrote:G'day Guys,
Still trying to figure a few things with this scanner.
I have encountered an issue that I can't bullshit my way through.
The scanner is set up to scan a number of profiles (i.e. Dist 04, Dist 08, Dist 27, MMR, Aviation)
All the other profiles are locked out.
All the service types are selected and there are no avoids on.
When it scans it will miss the Aviation profile I have checked by scanning the systems to find that it misses it out completely.
The AM channels are all correct.
There are no avoids set
The profile is ON to scan in scan selection
The service type for this profile is ON
I have looked at everything in the Sentinel program and it all looks good.
I have looked at everything in the Scanner itself and it all looks good.
Does anyone have any ideas that will prevent my scanner being impact tested against the bricks of my house?
Signed sincerely
Confused and aggravated
-
fletchba
- Registered User
- Posts: 13
- Joined: Thu Jul 04, 2013 8:18 pm
Re: Scanning issues with the UBCD436-PT
G'day Frank,
Yes yes I did.
I will do it again just in case!
Thanks for the tip.
Yes yes I did.
I will do it again just in case!
Thanks for the tip.