Hello, for some reason all of a sudden the CE91NF software will not open on my windows 7 computer. It was running perfectly yesterday but now it just comes up with... An unsupported operation was attempted.
Sent from my iPad using Tapatalk
My Vertex Standard CE91NF software problem
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
- GME Man
- Registered User
- Posts: 157
- Joined: Sun Sep 25, 2016 7:46 pm
- Location: Queensland
- Phantom
- Forum Manager
- Posts: 1306
- Joined: Thu May 15, 2008 12:28 pm
- Location: SE QLD
Re: My Vertex Standard CE91NF software problem
Where did you source the software from?
Suggest going back to them for support
Suggest going back to them for support
- GME Man
- Registered User
- Posts: 157
- Joined: Sun Sep 25, 2016 7:46 pm
- Location: Queensland
Re: My Vertex Standard CE91NF software problem
Someone sent it to me from Austech forums
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk
GME Man
-
- Senior Member
- Posts: 376
- Joined: Tue Oct 05, 2010 11:27 am
Re: My Vertex Standard CE91NF software problem
First, uninstall and reinstall, or contact the supplier, which should have been the first thing you did.