CS-400PRO for Icom IC-400PRO
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
RoyButterfield
- Newly Registered Users
- Posts: 1
- Joined: Thu Oct 17, 2013 8:34 am
Re: CS-400PRO for Icom IC-400PRO
Why do I need a dealer ID ?
-
rochedalescan
- Founder
- Posts: 1632
- Joined: Fri Jun 01, 2007 5:08 pm
- Location: Brisbane
- Contact:
Re: CS-400PRO for Icom IC-400PRO
Are you talking about product I.D ? on installation ? if so read the document called READ ME and it has that information in there.
Shane Logan
Aussiescanners Founder
Australia's Premier Communications forum!
~ Please contact Phil for administration enquiries ~
Aussiescanners Founder
Australia's Premier Communications forum!
~ Please contact Phil for administration enquiries ~