Page 1 of 1
Re: Icom OPC478 & 478U
Posted: Wed May 27, 2009 5:39 pm
by bananaman
Is this a programing cable? If so does this do the IC41's?
Re: Icom OPC478 & 478U
Posted: Mon Aug 10, 2009 6:22 pm
by 878ROB
how much including postage to NZ postcode 3977
Re: Icom OPC478 & 478U
Posted: Mon Aug 10, 2009 6:44 pm
by bonnie28
Please tell me ! Can this radio be programmed to accept other frequencies apart from the standard 40 channels ? And if so what frequency range does it have ? Can they be programmed manualy with out the cable ?
Re: Icom OPC478 & 478U
Posted: Mon Aug 10, 2009 6:49 pm
by 878ROB
this is a programming cable for handheld icoms i think
Re: Icom OPC478 & 478U
Posted: Mon Aug 10, 2009 10:22 pm
by Fireman_DJ
From the dealers software help manual for the IC-41S,
Private channel frequency range (2.5 k and 3.125k steps):
RX : 450 to 520 MHz
TX : 450 to 480 MHz
However there is an extra program that can program out to the full 520 MHz.
You can program RX ONLY channels on the unit, you must have the cable and the dealers software to program TX.
The IC-41S has 128 channels total. They can be 40 or 48 (as is default) for CB and the rest for commercial. Or you can use the full 128 for commercial and have none on CB.
Needless to say, you must be licenced to use those freqs.
Re: Icom OPC478 & 478U
Posted: Tue Aug 11, 2009 9:45 am
by bonnie28
can it be programed manually