Hi All,
Hope everyone has had a good christmas!
I am new to the programming scene and have searched the forum but cannot find an answer.
I have a SRP9180, and tried programming some Tasfire channels into it using FPP, it asked me to downgrade the radio software from V2.30 to V2.13, which i did, and since then the screen has moved alignment, and has a section on the left that just has dots.
I cannot find any downloadable software to put it back to V2.30.
Any solutions or suggestions you have would be great. Thanks for the assistance.
SRP9180 Screen Issue and Software
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
Moonface
- Newly Registered Users
- Posts: 2
- Joined: Mon Dec 28, 2020 1:12 pm