Hello everyone, the software I use for my Motorola GM338 uhf will not read the radio. The version of CPS is R06.12.02 which has been working fine for months but all of a sudden it will not read my radio, even when I click read radio and check that the com port is correct. I am probably doing one simple thing wrong but if anyone has had this problem before can you please let me know.
Cheers
GM338 software problem
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
- GME Man
- Registered User
- Posts: 157
- Joined: Sun Sep 25, 2016 7:46 pm
- Location: Queensland
GM338 software problem
GME Man
- Phantom
- Forum Manager
- Posts: 1306
- Joined: Thu May 15, 2008 12:28 pm
- Location: SE QLD
Re: GM338 software problem
Cable problems? Driver problems?
- GME Man
- Registered User
- Posts: 157
- Joined: Sun Sep 25, 2016 7:46 pm
- Location: Queensland
Re: GM338 software problem
Don't think there are any cable or driver problems as I have double checked and I have also tried it on a friends pc, which worked properly because it's a genuine cable. I will keep having a muck around with it and hopefully get this issue solved.
Thanks
Sent from my iPad using Tapatalk
Thanks
Sent from my iPad using Tapatalk
GME Man
-
- Senior Member
- Posts: 703
- Joined: Sat Jun 02, 2007 5:27 pm
- Location: Earth around the Gold Coast Area.
Re: GM338 software problem
So if you pull out the comm plug from the computer in the port section it also disappears from there?
you push it back in and port 5 ect.... appears.
make sure that in the com port section of the M program you have selected the right port.
you need to go direct into the program to find this.
you push it back in and port 5 ect.... appears.
make sure that in the com port section of the M program you have selected the right port.
you need to go direct into the program to find this.
- GME Man
- Registered User
- Posts: 157
- Joined: Sun Sep 25, 2016 7:46 pm
- Location: Queensland
Re: GM338 software problem
Yes I have double checked this but like I said in the first post, I am probably just doing one simple thing wrong
GME Man
-
- Senior Member
- Posts: 703
- Joined: Sat Jun 02, 2007 5:27 pm
- Location: Earth around the Gold Coast Area.
Re: GM338 software problem
remove the program and all trace of it in the Common files. then reinstall it, might work.
-
- Senior Member
- Posts: 376
- Joined: Tue Oct 05, 2010 11:27 am
Re: GM338 software problem
One thing about these sorts of things, sometimes the leads will only work if they are plugged into the USB port that was used when the driver was installed.