PSR-500

Discussion on any technologies that do not fall under one of the above vendors, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
aircadet
Newly Registered Users
Posts: 3
Joined: Mon Oct 11, 2010 11:23 am
Location: Illawarra NSW

PSR-500

Post by aircadet » Wed Jan 12, 2011 7:51 pm

Just purchased the PSR-500,issue with the NSW GRN.... can see the talk groups appear on analogue and digital but getting no sound..... most frustrating!!
Anyone got any clues???

Thanks

User avatar
Doogs38
Registered User
Posts: 113
Joined: Fri Apr 16, 2010 6:29 pm
Location: Walloon
Contact:

PSR-500

Post by Doogs38 » Thu Jan 13, 2011 9:05 am

I had a similar issue with my 396T the first time I attempted to listen to the digital NSW GRN. After some searching I discovered that I'd entered a setup parameter incorrectly although, I cannot recall which one (and I'm not near my scanner to have a look). As a friendly suggestion, recheck the GRN network parameters you've entered into your radio.


Sent from my iPhone using Tapatalk
-----------
Alex www.pbase.com/doogs38

Post Reply