Hi iam having problem with programming my Tx7200 iam using win98 i tried both cable that i have but it keep coming up with Comms Error "Radio response timeout". can anyone help with this
thanks
nick
Problems programming gme tx7200
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
nichstein
- Newly Registered Users
- Posts: 1
- Joined: Sat Jul 14, 2012 12:42 am
- Location: Ipswich,QLD
-
Phantom
- Forum Manager
- Posts: 1306
- Joined: Thu May 15, 2008 12:28 pm
- Location: SE QLD
-
rochedalescan
- Founder
- Posts: 1632
- Joined: Fri Jun 01, 2007 5:08 pm
- Location: Brisbane
- Contact:
Problems programming gme tx7200
It sounds like an issue with the comm port, are you using a USB programming cable?
Welcome to the forums ^^
Welcome to the forums ^^
Shane Logan
Aussiescanners Founder
Australia's Premier Communications forum!
~ Please contact Phil for administration enquiries ~
Aussiescanners Founder
Australia's Premier Communications forum!
~ Please contact Phil for administration enquiries ~