GME TX3400

Discussion on GME technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
User avatar
Scannersplitterguy
Registered User
Posts: 557
Joined: Sun Apr 12, 2009 10:44 pm
Location: Sunshine Coast, QLD

Re: GME TX3400

Post by Scannersplitterguy »

Hi Scott, I've got both service and user manuals for this model but there is no mention of how to do a hard reset.
Try disconnecting the power for 10 mins then powering up normally and see what happens.
If that doesn't work, try holding in two or more front panel buttons for a few seconds while switching the radio on. Note: holding in just one button will disable the function of that button.
Failing that, call GME - their techs would probably know how to reset the radio.
http://www.scannerantennasplitter.com
http://www.acdcmanuals.com
AOR AR8200MK3, Icom IC-R75, UBC370CRS, UH7750NB, SR162 VHF AIS, SDR USB Dongle, Anytone AT-6666, Pearce Simpson Super Cheetah 27 MHz AM/SSB, QJE QJ-PS30II 30A PSU, Diamond DJ-130 Discone, Shockwave 5/8 27MHz, DIY HF longwire
Top
User avatar
Phantom
Forum Manager
Posts: 1306
Joined: Thu May 15, 2008 12:28 pm
Location: SE QLD

GME TX3400

Post by Phantom »

Whilst ur on the phone to the techs, ask them if there is an upgrade available to the 77/80ch allocation that will be here in a few years!

Saves making two calls....

I know the 3420 can be upgraded, nor sure about the 3400.
Top
Post Reply

Return to “GME”