I've looked through the GME dealer software for a way to enable CTCSS on repeaters. Very soon ACMA will be allowing CTCSS on CB repeaters as a way to counteract the narrow band adjacent channels interference (except Ch 5/45).
I can't see this in the software but I was sure it is there. What am I missing?
Cheers. Mark
Sent from my SM-G900I using Tapatalk
TX3200 CTCSS enable on Duplex
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
MarkSR24
- Newly Registered Users
- Posts: 3
- Joined: Tue Nov 14, 2017 12:50 pm
-
MarkSR24
- Newly Registered Users
- Posts: 3
- Joined: Tue Nov 14, 2017 12:50 pm
Re: TX3200 CTCSS enable on Duplex
Well I've answered my own question so stop looking.
In the software hit the "Engineering" feature and it's in there. Just tick the "CTCSS on Dulpex" box and that's it.
Cheers
Sent from my SM-G900I using Tapatalk
In the software hit the "Engineering" feature and it's in there. Just tick the "CTCSS on Dulpex" box and that's it.
Cheers
Sent from my SM-G900I using Tapatalk