Hi all
I recently inherited some radio equipment including a large array of antennas, some are whip, also now have a 5/6 element beam antenna for an amateur radio (radio not included)
Is there a way based on the length of the antenna I can find out what freq it would cover. One has been labeled 27mhz, however, the others have no identifying marks
Thanks in advance
VK3YMML
Antenna Identification
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
- VK3RX
- Registered User
- Posts: 156
- Joined: Fri Oct 27, 2017 7:18 pm
- Location: Woodend, Victoria
Re: Antenna Identification
Some pix might assist.
Helically wound types with heatshrink covering can be a bit difficult to identify, but someone may recognise a model. They can be for anywhere over the HF range, and typically the longer ones for lower frequencies, shorter ones for higher e.g. 5 feet or less usually for 27/28MHz.
Other than recognising a model, the only sure way to determine the frequency would be to connect an antenna to a mount (e.g. on a vehicle) or ground plane and use an antenna analyser.
For stainless steel whips, with no base loading coil try this:
http://www.qsl.net/kd4sai/antencal.html
Example: for 146MHz in the 2 Metre amateur band, the length of a quarter wave whip is 19"
If a whip has a base loading coil, again an antenna analyser would be the only sure way to find out the frequency range.
Helically wound types with heatshrink covering can be a bit difficult to identify, but someone may recognise a model. They can be for anywhere over the HF range, and typically the longer ones for lower frequencies, shorter ones for higher e.g. 5 feet or less usually for 27/28MHz.
Other than recognising a model, the only sure way to determine the frequency would be to connect an antenna to a mount (e.g. on a vehicle) or ground plane and use an antenna analyser.
For stainless steel whips, with no base loading coil try this:
http://www.qsl.net/kd4sai/antencal.html
Example: for 146MHz in the 2 Metre amateur band, the length of a quarter wave whip is 19"
If a whip has a base loading coil, again an antenna analyser would be the only sure way to find out the frequency range.