My Vertex Standard CE91NF software problem

Discussion on Yaesu / Vertex technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
User avatar
GME Man
Registered User
Posts: 157
Joined: Sun Sep 25, 2016 7:46 pm
Location: Queensland

My Vertex Standard CE91NF software problem

Post by GME Man » Tue Dec 06, 2016 12:01 pm

Hello, for some reason all of a sudden the CE91NF software will not open on my windows 7 computer. It was running perfectly yesterday but now it just comes up with... An unsupported operation was attempted.Image


Sent from my iPad using Tapatalk
GME Man

User avatar
Phantom
Forum Manager
Posts: 1305
Joined: Thu May 15, 2008 12:28 pm
Location: SE QLD

Re: My Vertex Standard CE91NF software problem

Post by Phantom » Tue Dec 06, 2016 12:13 pm

Where did you source the software from?
Suggest going back to them for support

User avatar
GME Man
Registered User
Posts: 157
Joined: Sun Sep 25, 2016 7:46 pm
Location: Queensland

Re: My Vertex Standard CE91NF software problem

Post by GME Man » Tue Dec 06, 2016 12:18 pm

Someone sent it to me from Austech forums


Sent from my iPad using Tapatalk
GME Man

Vkfour
Senior Member
Posts: 357
Joined: Tue Oct 05, 2010 11:27 am

Re: My Vertex Standard CE91NF software problem

Post by Vkfour » Tue Dec 06, 2016 1:46 pm

First, uninstall and reinstall, or contact the supplier, which should have been the first thing you did.

Post Reply