New firmware available for the SDS200 (U.S. model)

Discussion on Uniden technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
User avatar
Registered User
Posts: 156
Joined: Fri Oct 27, 2017 7:18 pm
Location: Woodend, Victoria

New firmware available for the SDS200 (U.S. model)

Post by VK3RX »

For those of us with the U.S. model SDS200, there is new firmware available.

The update requires the latest version of the U.S. models Sentinel software to load to the SDS200.

Note that
  • this firmware is only for the U.S. model SDS200, not the SDS200e;
  • this version of Sentinel is only for the U.S. model scanners.
The change log doesn't say what bugs have been fixed and some say the audio is improved, but I can't say at this stage I've noticed any difference.

BCDx36HPSentinel: ... HPSentinel

SDS200 Firmware Update Change Log: ... _6_29_2022
Newly Registered Users
Posts: 1
Joined: Mon Aug 13, 2018 4:25 pm
Location: Blue Mountains, NSW

Re: New firmware available for the SDS200 (U.S. model)

Post by Commshack »

New firmware with waterfall support for the Uniden SDS200E is now available thru Sentinel as of today
Post Reply