Howdy all from lockdown in Newcastle.
Lockdown has seen me finally have time to purchase the firmware update for my 325P2, just the DMR at this stage.
I have the 'key', how do i upload the new version to the scanner?
Tried Unidens BC-VUP option and it wont upload the Australian version.
Ozscans page suggested going to FREESCAN and uploading the new Aussie version but the links are all SPAM.
Im presuming theres another patch out there somewhere or does Uniden post a physical disc when paid for?
Uploading new Firmware for 325P2
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
- Registered User
- Posts: 12
- Joined: Fri Jun 17, 2016 12:53 pm
- VK3RX
- Registered User
- Posts: 156
- Joined: Fri Oct 27, 2017 7:18 pm
- Location: Woodend, Victoria
Re: Uploading new Firmware for 325P2
Did you try the version on Uniden Australia's site:
https://uniden.com.au/wp-content/upload ... _03_04.zip
If it doesn't work, drop Jim @ Ozscan a line.
https://uniden.com.au/wp-content/upload ... _03_04.zip
If it doesn't work, drop Jim @ Ozscan a line.
-
- Registered User
- Posts: 12
- Joined: Fri Jun 17, 2016 12:53 pm
Re: Uploading new Firmware for 325P2
I looked and searched for such a link and for the life of me it would not come up. Presumed there was something there but nope, every search came up nil. Thanks so much will try it in the morning.
-
- Registered User
- Posts: 12
- Joined: Fri Jun 17, 2016 12:53 pm
Re: Uploading new Firmware for 325P2
Thanks again Damien. Turns out my scanner is a BCD325P, not a UBCD325P, and the firmware will not upload. Will contact Jim and see what he reckons, thanks again.