Hi guys. I have the icom 400pro with some custom banks made for police ect. Running the 80channel ICF file.
Lately whenever anyone talks over he 2 way after they finish talking I get a static sound goes for about 3 seconds it's getting annoying what is going on with it? Any ideas????
Thanks guys
ICOM 400pro static sound
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
- Registered User
- Posts: 7
- Joined: Mon Oct 12, 2015 5:34 pm
ICOM 400pro static sound
Ic-400Pro & IC-41W
- RadioKid
- Registered User
- Posts: 81
- Joined: Wed Jul 13, 2016 11:02 pm
- Location: Western Sydney
Re: ICOM 400pro static sound
I dont know if it is similar to the Icom setup, but my Oricom UHF does the same thing. It is a setting where it opens the squelch for a designated amount of time after recieving a signal.
Hope this helps,
Matty
Sent from my GT-I9506 using Tapatalk
Hope this helps,
Matty
Sent from my GT-I9506 using Tapatalk
Uniden UBC126AT, Baofeng GT3
-
- Registered User
- Posts: 7
- Joined: Mon Oct 12, 2015 5:34 pm
Re: ICOM 400pro static sound
Yeah mate sounds like the same thing. Not sure what to do!
Ic-400Pro & IC-41W
- Phantom
- Forum Manager
- Posts: 1306
- Joined: Thu May 15, 2008 12:28 pm
- Location: SE QLD
Re: ICOM 400pro static sound
Did it change after you altered any settings?