Motorola GM338 frequency range
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
GME Man
- Registered User
- Posts: 157
- Joined: Sun Sep 25, 2016 7:46 pm
- Location: Queensland
Motorola GM338 frequency range
Hi I have got a Motorola GM338 radio and apparently you can get them in a couple of different frequency ranges, turns out I have the one from 450-520MHz and of course I want one from 403-470MHz. Is there a way to change that?, Maybe through software or firmware.
GME Man
-
alinco21
- Senior Member
- Posts: 703
- Joined: Sat Jun 02, 2007 5:27 pm
- Location: Earth around the Gold Coast Area.
Re: Motorola GM338 frequency range
Not that I am aware of, (but someone might know)
CB freqs can be programmed into them provided the CPS is set at 5 watts Tx, but as this not approved radio for CB usage. (Will leave that alone)
There are a few GM339 or GM338 on ebay that are UHF low.
item 3.0 explains the model numbers on the radio.
http://diagramasde.com/diagramas/otros2 ... Manual.pdf
possibly sell it and look for the other model.
hope it helps.
CB freqs can be programmed into them provided the CPS is set at 5 watts Tx, but as this not approved radio for CB usage. (Will leave that alone)
There are a few GM339 or GM338 on ebay that are UHF low.
item 3.0 explains the model numbers on the radio.
http://diagramasde.com/diagramas/otros2 ... Manual.pdf
possibly sell it and look for the other model.
hope it helps.
-
GME Man
- Registered User
- Posts: 157
- Joined: Sun Sep 25, 2016 7:46 pm
- Location: Queensland