To activate these codes please press and hold the following keys as you turn on the EZI30XLT.
HOLD = Change country mode (AUS / NZ) Also enables / disables the global 2 second delay
1 + Up arrow = 88MHz search
SRVC + VOL = 136 - 136.1MHz search
SRVC + 2 = Load test frequencies MISC band
SRVC + Down arrow = 477 - 477.1MHz search
SRVC + SQ = Band signal levels (90MHz)
SRVC + 3 = 143 - 143.1MHz search
HOLD + 2 = Full reset
HOLD + Down arrow = Firmware version (1.33 / CbbbH)
VOL + Up arrow = Screen / key test. Shows all screen icons and keys as they are pressed.
2 + Up arrow = full band search 75MHz - 489MHz
Up arrow + Down Arrow = 137 - 147MHz search
Up arrow + SQ = Band signal levels. VHF High -> AIR -> FM -> UHF -> VHF Mid
Up arrow + 3 = Load test frequencies
http://tasmanianairbandscanning.blogspo ... codes.html
Uniden EZI30XLT Scanner - Key Press Codes
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
- Senior Member
- Posts: 181
- Joined: Tue Apr 19, 2011 12:01 pm
- Contact:
Re: Uniden EZI30XLT Scanner - Key Press Codes
thankyou for providing these codes had a bit of fun with them. always love little secrets built into the firmware