Just purchased the PSR-500,issue with the NSW GRN.... can see the talk groups appear on analogue and digital but getting no sound..... most frustrating!!
Anyone got any clues???
Thanks
PSR-500
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
Doogs38
- Registered User
- Posts: 113
- Joined: Fri Apr 16, 2010 6:29 pm
- Location: Walloon
- Contact:
PSR-500
I had a similar issue with my 396T the first time I attempted to listen to the digital NSW GRN. After some searching I discovered that I'd entered a setup parameter incorrectly although, I cannot recall which one (and I'm not near my scanner to have a look). As a friendly suggestion, recheck the GRN network parameters you've entered into your radio.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
-----------
Alex www.pbase.com/doogs38
Alex www.pbase.com/doogs38