Welcome to the Aussie Scanners group, register today and join in the fun!!!  The main website, forum and tapatalk have all been updated...  Why not introduce yourself in the member introductions forum ? ...

Antenna Identification

Discussion on any technologies that do not fall under one of the above vendors, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.

Antenna Identification

Postby VK3YMML » Sun Dec 03, 2017 8:13 am

Hi all

I recently inherited some radio equipment including a large array of antennas, some are whip, also now have a 5/6 element beam antenna for an amateur radio (radio not included)

Is there a way based on the length of the antenna I can find out what freq it would cover. One has been labeled 27mhz, however, the others have no identifying marks

Thanks in advance
VK3YMML
VK3YMML
Registered User
 
Posts: 11
Joined: Sat Mar 14, 2015 11:02 am

Re: Antenna Identification

Postby VK3RX » Sun Dec 03, 2017 12:58 pm

Some pix might assist.

Helically wound types with heatshrink covering can be a bit difficult to identify, but someone may recognise a model. They can be for anywhere over the HF range, and typically the longer ones for lower frequencies, shorter ones for higher e.g. 5 feet or less usually for 27/28MHz.

Other than recognising a model, the only sure way to determine the frequency would be to connect an antenna to a mount (e.g. on a vehicle) or ground plane and use an antenna analyser.

For stainless steel whips, with no base loading coil try this:

http://www.qsl.net/kd4sai/antencal.html

Example: for 146MHz in the 2 Metre amateur band, the length of a quarter wave whip is 19"

If a whip has a base loading coil, again an antenna analyser would be the only sure way to find out the frequency range.
User avatar
VK3RX
Registered User
 
Posts: 9
Joined: Fri Oct 27, 2017 7:18 pm


Return to Miscellaneous

Who is online

Users browsing this forum: No registered users and 7 guests