Heres my issue:
SRM9000 programmed with a mix of analogue & P25 Conventional also have a P25 trunking set in there as well.
All through the p25 side (not pmr) I have broken it into 3 zones reflecting the above.
Zone 1: Ana con, Zone 2: P25 Con Zone 3: Trunking P25.
When I program the radio I can get the Z1 working but none of the others.
If I remove the other zones from being programmed still nothing on the P25 side.
I have tried slotting a P25 Con into the Ana side, all but the P25 chan works.
It programs fine with no errors but wont work.
Can anyone help?
Oh and yes it does have the appropriate hardware. (I am told)
P25 Programming issue
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.