G'day Everyone,
We have a group of new Tait TP9300's being used at our plant.
The supplier has programed them with Reverse Tone Burst to mute the squelch tail.
Our guys are now unsure if they are transmitting as they are so accustom to hearing the tail on our previous radios, they have asked if the squelch tail be restored (mute removed).
Via the Tait software we went across
Networks – Basic Settings – Subaudible Signalling
and changed the ‘Reverse Tone Burst Duration’ from the default of 130ms to 0.
Programed and Tested against our repeater onsite, Unfortunately still no squelch tail.
Also tried a setting of 1, but with no result again"
Has anyone had this issue before? or more settings to disable across subaudile signalling"
Any help would be great!
Thanks!
Matt
Tait TP9300 Squelch Tail
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
MujaPS
- Newly Registered Users
- Posts: 1
- Joined: Mon Sep 01, 2014 11:21 am
-
Phantom
- Forum Manager
- Posts: 1306
- Joined: Thu May 15, 2008 12:28 pm
- Location: SE QLD
Re: Tait TP9300 Squelch Tail
Welcome to the forum!
I could suggest CTCSS to mute a repeater tail?
I could suggest CTCSS to mute a repeater tail?