Bearcat BC125AT

Discussion on Uniden technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
Mervo44
Registered User
Posts: 16
Joined: Fri Jun 03, 2011 12:50 am

Bearcat BC125AT

Post by Mervo44 » Fri Nov 11, 2016 7:02 am

Hi there, Is there anyone out there who could guide me through using the search function. I want to be able to enter two frequencies, a lower and upper frequency into my scanner then search between the two frequencies. Any assistance greatly appreciated.

Merv
Adelaide.

Newy1234
Registered User
Posts: 160
Joined: Mon Apr 16, 2012 8:51 pm

Re: Bearcat BC125AT

Post by Newy1234 » Fri Nov 11, 2016 8:05 am


Post Reply