Some years ago I programmed my UBC780XLT with the ARC780 program Ver 1.18
I found recently that I had not re installed the program on my new computer.
I have now installed the program and I have a registration key which it accepts, but each time I open the program it says its the demo and have to re enter the registration key.
Any help please?
ARC780 Prog
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
- Registered User
- Posts: 201
- Joined: Sun Jan 23, 2011 2:36 pm
Re: ARC780 Prog
Contact the BuTel website or the dealer where the software was purchased from and they will resend your registration code.
They will need the following - http://www.butel.nl/lost.html
They will need the following - http://www.butel.nl/lost.html