Hi All
Its been a couple of years since I turned on my Uniden UBCD395T. Of course with the GRN update, its a silent unit now!
I am looking for someone whom could re program my scanner for me, including upgrading the firmware.
Keen to program GRN, with approx 10 sites.
Main TG's to be programmed are into categories such as RFS, FRNSW etc, with then a few key TG's as favourites.
Also then looking to add some RFS PMR channels
Hoping there might be someone in this group that is a guru with all things programming. Of course, happy to pay for the service!
Anyone that can help, would appreciate an email ASAP to ajwaus@hotmail.com
Cheers. Anthony
Someone to Program UBCD396T
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
- Newly Registered Users
- Posts: 1
- Joined: Sun Sep 14, 2014 4:51 pm