ubcd396xt programming

Discussion on Uniden technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
smithy658
Registered User
Posts: 9
Joined: Wed May 21, 2014 1:22 pm

ubcd396xt programming

Post by smithy658 »

Hello
Ive just got my scanner up and running , ive got a couple of towers that im receiving p25 from is there any way I can prioritize so it only gets the strongest signal out of the 4 towers depending where I am , im using freescan if thats any help Cheers :D
Top
vkcpolice

Re: ubcd396xt programming

Post by vkcpolice »

The only way would to be lock out the towers with the weaker system or press function pri on the main systems you listen to.
Top
Post Reply

Return to “Uniden”