Tx7200 Programing software needed

Discussion on GME technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
haynzie
Newly Registered Users
Posts: 1
Joined: Sun Jun 19, 2011 9:00 am

Tx7200 Programing software needed

Post by haynzie »

I have a tx7200 and programming lead but i need the software to program it. I was wondering if anyone could tell me where to get it from?
Top
User avatar
Phantom
Forum Manager
Posts: 1306
Joined: Thu May 15, 2008 12:28 pm
Location: SE QLD

Tx7200 Programing software needed

Post by Phantom »

Welcome to the forum.

Here is a place to start




I will have a dig around, as I am sure I have it somewhere
Top
dwablack
Newly Registered Users
Posts: 1
Joined: Thu May 23, 2013 8:38 am

Re: Tx7200 Programing software needed

Post by dwablack »

Hi,

I'm in the same position also, and looking for TX7200 software.

Thanks
Top
misspat43
Newly Registered Users
Posts: 2
Joined: Fri Jan 25, 2008 7:00 am

Re: Tx7200 Programing software needed

Post by misspat43 »

me too
Top
Nightwalker79
Newly Registered Users
Posts: 3
Joined: Mon Jan 18, 2016 5:43 am

Re: Tx7200 Programing software needed

Post by Nightwalker79 »

Hi All

I'm in abit of a pickle.... My Pc with my GME TX7200 prog software has craped itself and I cannot find the disk. Can someone help a old bloke out please. Having be searching the net and I have googleitis.
Thanks in advanced :)
Top
Post Reply

Return to “GME”