Welcome to the Aussie Scanners group, register today and join in the fun!!!  The main website, forum and tapatalk have all been updated...  Why not introduce yourself in the member introductions forum ? ...

GME Telemetry Radio Software

Discussion on GME technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.

GME Telemetry Radio Software

Postby MarkSR24 » Wed Nov 15, 2017 10:17 pm

Looking for GME Telemetry radio dealer software (Australia NZ) for TX3600-TX3800. I have a UHF CB repeater that uses 2 x TX3600T. The TX radio OP device has failed and I want to either swap the RX/TX radios around or convert a spare TX3800 PMR radio to a telemetry version as the repeater TX radio. Both TX and RX radios are connected to a RP3800 interconnect board. I understand I actually need to "flash" new firmware into the TX3800 using a different cable (9 PIN D to 10 pin header inside radio) to make it work as a telemetry radio. Of course with my existing software I can configure the TX3800 to accept control from the TX3600 RX radio, but I'd rather just swap around the failed radio and that's why I need the Telemetry Software to reconfigure them. Cheers.

Sent from my SM-G900I using Tapatalk
MarkSR24
Newly Registered Users
 
Posts: 1
Joined: Tue Nov 14, 2017 12:50 pm

Re: GME Telemetry Radio Software

Postby Phantom » Wed Nov 15, 2017 11:13 pm

Welcome to the forum. Interesting first post
User avatar
Phantom
Forum Manager
 
Posts: 1299
Joined: Thu May 15, 2008 12:28 pm
Location: SE QLD

Re: GME Telemetry Radio Software

Postby paul02 » Thu Nov 23, 2017 3:48 pm

[quote="MarkSR24"]Looking for GME Telemetry radio dealer software (Australia NZ) for TX3600-TX3800.

Sounds like you need CCK3600 software :wink:
Keep looking, nothing worst than asking questions and getting no replies.
If I can help will send private post :D
User avatar
paul02
Newly Registered Users
 
Posts: 2
Joined: Thu Nov 23, 2017 3:20 pm

Re: GME Telemetry Radio Software

Postby paul02 » Fri Dec 01, 2017 1:55 pm

All done for you MarkSR24, latest version for TX3600T and TX3600P. That's how helping on forum's should be ; )
User avatar
paul02
Newly Registered Users
 
Posts: 2
Joined: Thu Nov 23, 2017 3:20 pm


Return to GME

Who is online

Users browsing this forum: No registered users and 3 guests