CS-450 Cloning Software

Discussion on Icom technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
pete_IC400pro
Newly Registered Users
Posts: 3
Joined: Sun Jun 05, 2016 4:10 pm

CS-450 Cloning Software

Post by pete_IC400pro » Sun Sep 11, 2016 11:31 am

Hi all,

I have an IC-400 and the CS-400 cloning software but now I also have an IC-450 that I want to setup the same, I haven't been able to find a copy of the CS-450 cloning software and I'm hoping someone on here is able to help me out.

Thanks,
Peter

XesyScan
Newly Registered Users
Posts: 1
Joined: Wed Jan 24, 2018 8:52 am

Re: CS-450 Cloning Software

Post by XesyScan » Wed Jan 24, 2018 10:24 am

Digging up this old post to say that there's users software on the iCom Australia website, but without a product ID it's useless. I haven't found a working product ID for the CS-450 software yet.

Post Reply