Hello,
I have a pair of Icom IC-F60V transceivers. I've been playing around with different RS-232 settings using the CS-F50 software. I changed the RS-232C settings to connection speed "9600" and mode "PC CMD" and now I receive the error "No answer from transceiver".
Is there a way to reset the configuration data or anything else I can do?
I'm ultimately trying to transmit data from a serial port over UHF.
Thank!
Icom F60V configuration reset?
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
-
Sbyti
- Newly Registered Users
- Posts: 1
- Joined: Sat Jul 18, 2015 2:38 pm