Icom F60V configuration reset?

Discussion on Icom technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
Sbyti
Newly Registered Users
Posts: 1
Joined: Sat Jul 18, 2015 2:38 pm

Icom F60V configuration reset?

Post by Sbyti » Sat Jul 18, 2015 2:54 pm

Hello,

I have a pair of Icom IC-F60V transceivers. I've been playing around with different RS-232 settings using the CS-F50 software. I changed the RS-232C settings to connection speed "9600" and mode "PC CMD" and now I receive the error "No answer from transceiver".

Is there a way to reset the configuration data or anything else I can do?

I'm ultimately trying to transmit data from a serial port over UHF.

Thank!

Post Reply