IC-F4163S help

Discussion on Icom technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
Post Reply
sirus
Newly Registered Users
Posts: 2
Joined: Sun Dec 23, 2012 8:37 am

IC-F4163S help

Post by sirus » Sun Dec 23, 2012 8:50 am

hey guys, im a newbie from down in brisbane, a friend of mine pointed me over here from another forum i asked for help on,
i picked up an icom IC-F4163S handheld but its programed to private freq's,
atm i cant really afford the cloning cable or the software (to close to chrisy) so i was wondering if anyone lives in south east qld around the logan area that has one and is willing to give me a hand to clone it back to factory, assuming that factory channels are standard uhf that is

Post Reply