Discussion on Icom technologies, including programming, tutorials, schematics, requests for help and new releases etc
Forum rules
***NOTE*** This forum and its content are not endorsed in any way by the vendor and users are advised to exercise caution when viewing and/or acting on any information contained within. We accept no responsibility for your devices and strongly warn you to check your warranty conditions and seek expert advice before proceeding.
by chocko761 » Wed Jan 31, 2018 10:18 am
Hi All,
I have the cloning software and I have cloned the channels I can receive but I can not transmit. Is there something that I need to turn on in the software before cloning or something else ?
-
chocko761
- Newly Registered Users
-
- Posts: 2
- Joined: Fri Jan 19, 2018 3:11 pm
Return to Icom
Who is online
Users browsing this forum: No registered users and 8 guests