Hi All,
I am having some trouble with UniTrunker, trying to decode the Victorian SMR network (MPT1327) with two SDR dongles. I have read over the tutorial and set everything up correctly, with the control channel audio (Mt Kerang, 164.9750MHz) coming through crystal clear. However, the 'Health' meter in UniTrunker displays 0. I have listened to a sample MPT1327 Control Channel online and have noticed a slight variation in sounds. Could this be affecting the the programs ability to decode? Any help would be very much appreciated.
Kind regards,
Mitch Baker
SMR with UniTrunker
-
- Registered User
- Posts: 116
- Joined: Fri Jan 30, 2015 6:58 am
SMR with UniTrunker
Mitch Baker - VK3GLV
Uniden UBCD396XT, BCT15X, UBCD996T, UBCD436-PT, Tait TM9100, Simoco SRM9000 (VHF + UHF DMAP), Icom IC-2730a, Codan 9323 (Codan 9030 Autotune Antenna), Retevis RT52
Uniden UBCD396XT, BCT15X, UBCD996T, UBCD436-PT, Tait TM9100, Simoco SRM9000 (VHF + UHF DMAP), Icom IC-2730a, Codan 9323 (Codan 9030 Autotune Antenna), Retevis RT52
-
- Registered User
- Posts: 9
- Joined: Thu Dec 31, 2015 2:59 pm
Re: SMR with UniTrunker
Hi, my limited experience with 2 dongles (1 an SDRplay) I found I was having to reinstall Zadig if it did something like you are describing.
FYI I am getting very good results with only 1 dongle though so don't bother with the SDRPlay as a signal source any more for Vic SMR network, would need it for RMR though due to the limited bandwidth with only 1 dongle.
Regards - Rob
FYI I am getting very good results with only 1 dongle though so don't bother with the SDRPlay as a signal source any more for Vic SMR network, would need it for RMR though due to the limited bandwidth with only 1 dongle.
Regards - Rob
-
- Registered User
- Posts: 116
- Joined: Fri Jan 30, 2015 6:58 am
Re: SMR with UniTrunker
Thanks for the reply Rob,
I have tried your solution and done some more fiddling around to no avail. I think I will buy a PC controllable scanner and have another go with TrunkView.
Thanks again,
I have tried your solution and done some more fiddling around to no avail. I think I will buy a PC controllable scanner and have another go with TrunkView.
Thanks again,
Mitch Baker - VK3GLV
Uniden UBCD396XT, BCT15X, UBCD996T, UBCD436-PT, Tait TM9100, Simoco SRM9000 (VHF + UHF DMAP), Icom IC-2730a, Codan 9323 (Codan 9030 Autotune Antenna), Retevis RT52
Uniden UBCD396XT, BCT15X, UBCD996T, UBCD436-PT, Tait TM9100, Simoco SRM9000 (VHF + UHF DMAP), Icom IC-2730a, Codan 9323 (Codan 9030 Autotune Antenna), Retevis RT52